Question:-- Which of the following are unique characteristics of half-duplex Ethernet as compared to full-duplex Ethernet? (Choose two.)

A. Shared collision domain.
B. Private collision domain
C. Higher effective throughput
D. Lower effective throughput
E. Private broadcast domain

Question:-- What is an advantage of using a connectionless protocol such as UDP?

A. Packet acknowledgement may reduce overhead traffic.
B. Loss or duplication of data packets is less likely to occur.
C. Packets are not acknowledged which reduces overhead traffic.
D. The application relies on the transport layer for sequencing of the data packets.

Question:-- Which two commands allow you to verify address configuration in your internetwork?

A. Ping
B. Trace
C. Verify
D. Test IP
E. Echo IP
F. Config IP

Question:-- Which statement is true when a broadcast is sent in an Ethernet/802.3 LAN?

A. The IP subnet used is 255.255.255.0
B. The IP address used is 255.255.255.255
C. The MAC address used is 00-00-00-00-00-00
D. The MAC address used is FF-FF-FF-FF-FF-FF.

Question:-- What are 4 ways network management can be simplified by using the virtual LANs (VLANs)? (Choose four)

A. VLANs allow you to implement multiple layers switching easily.
B. VLAN can group several broadcasts domains into multiple logical subnets.
C. It is no longer necessary to install cables to move a user from a new network to another.
D. Network adds, moves and changes are achieved by configuring a port into a VLAN.
E. A group of users needing high security can be put into a VLAN so that no users outside the VLANs can communicate with them.
F. As a logical grouping of users, VLANs can be considered independent from their physical or geographic locations.

Question:-- Which IOS command is used to associate an ISDN phone number with the next hop router address?

A. isdn destination number
B. dialer map
C. isdn spid1
D. isdn line number

Edited by - Tara on Jun 24 2002 10:06:26 PM

Question:-- Which technology do catalyst switches use to resolve topology loops and ensure data use flows properly through a single network path?

A. Virtual LANs.
B. Frame filtering.
C. Cut through switching.
D. Spanning tree protocol.

Question:-- When setting up Frame Relay for point-to-point subinterfaces, which of the following must not be configured?

A. The Frame Relay encapsulation on the physical interface
B. The local DLCI on each subinterface
C. An IP address on the physical interface
D. The subinterface type as point-to-point

I was wondering in addition to Cisco's first year & second year CCNA Companion guide if you would be able to recommend additional study guides or would these two books along with your forum be enough preparation to pass the CCNA? Would other study guides be beneficial in reviewing your 50 out of 50 questions? Are your questions coming from these books? If you think Cisco's first year & second year CCNA Companion guide are worth having and will assist in my studies I will invest in them.

thank you,
Missy

Question:-- configuration:RouterA
RouterA(config)#router igrp 100
RouterA(config-router)#network 192.168.3.0
RouterA(config-router)#network 192.168.4.0
RouterA(config-router)#network 192.168.5.0
RouterA(config-router)#network 172.16.0.0
configuration:RouterB
RouterB(config)#router igrp 100
RouterB(config-router)#network 192.168.3.0
RouterB(config-router)#network 192.168.6.0
RouterB(config-router)#network 192.168.7.0
Given the router configuration shown, which networks will be found in RouterB's routing table,assuming a properly configured network?

A.192.168.3.0
192.168.4.0
192.168.5.0
192.168.6.0
192.168.7.0
172.16.0.0

B.192.168.3.0
192.168.6.0
192.168.7.0

C.192.168.3.0
192.168.4.0
192.168.5.0
192.168.6.0
192.168.7.0

D.172.16.0.0

E.192.168.3.0
192.168.4.0
192.168.5.0

Edited by - Tara on Jun 27 2002 11:04:54 AM

Question:-- Which line from a show spantree one-command output indicates that Virtual LAN1 (VLAN1) is functioning properly?

A. Root mode is fast Ethernet 0/26.
B. Port Ethernet 0/1 of VLAN is forwarding.
C. Designated port in Ethernet 0/1 path cos10.
D. Designated root has priority 0, address 0000.588fb600
E. VLAN1 is executing the IEEE compatible spanning tree protocol.

quote:

---

* TARA'S CISCO TARGET *

Question:-- configuration:RouterA
RouterA(config)#router igrp 100
RouterA(config-router)#network 192.168.3.0
RouterA(config-router)#network 192.168.4.0
RouterA(config-router)#network 192.168.5.0
RouterA(config-router)#network 172.16.0.0
configuration:RouterB
RouterB(config)#router igrp 101
RouterB(config-router)#network 192.168.3.0
RouterB(config-router)#network 192.168.6.0
RouterB(config-router)#network 192.168.7.0
Given the router configuration shown, which networks will be found in RouterB's routing table,assuming a properly configured network?

A.192.168.3.0
192.168.4.0
192.168.5.0
192.168.6.0
192.168.7.0
172.16.0.0

B.192.168.3.0
192.168.6.0
192.168.7.0

C.192.168.3.0
192.168.4.0
192.168.5.0
192.168.6.0
192.168.7.0

D.172.16.0.0

E.192.168.3.0
192.168.4.0
192.168.5.0

Members are requested to go through
Cisco's first year & second year CCNA Companion guide
to know more about the subject rather then collecting
question & answer.

Love

Tara's Help Desk.

---

Hi Tara,

Unfortunately you are wrong. THe correct answer is B.
Look out for the # of the AS!
100 != 101 so B answer

regards kros

Question:-- Which Cisco IOS command should you use to display the Novel IPX address assignments on a router?

A. Show IPX addresses.
B. Show IPX interface.
C. IPX network
D. Display IPX addresses
E. Show IPX routing details

Question:-- Which statement about the data-link connection identifier (DLCI) is true?

A. It is a number that identifies a local virtual circuit in Frame Relay network.
B. It is a signaling standard between the CPE device and the Frame Relay switch.
C. It is check speed port speed of the connection (local loop) to the Frame Relay cloud.
D. It is maximum number of uncommitted bits that the Frame Relay switch will attempt to transfer beyond the committed information rate (CIR).

My email:

Thank you very much
TSOn

TSon

Question:-- What are four benefits that can result from applying ISDN networking?(Choose four).

A. Full time connectivity across the ISDN supported by Cisco IOS routing using dial on demand routing DDR.
B. Small office and home office sites can be economically supported with ISDN basic rate interface BRI services.
C. ISDN replaces signaling system ss7 in the public switch telephone network PSTN backbone.
D. ISDN can be used as a backup service for a lease line connection between the remote and central offices.
E. Modem racking and cabling can be eliminated by integration with digital modem cards on Cisco IOS network access servers NAS.

Please Note: To answer this type of question in the exam, Take the ODD MAN OUT, to save your time.

Question:-- While you are preparing the initial configuration of your router and enable IP you find that you need to use a telnet session to check for a network address parameter. Your telnet logging and your virtual transmission session on the other device are successful. What is the default that you must enter to suspend your Telnet session and return to the original router?

A. Suspend
B. The command exit
C. CTRL – ESC followed by x
D. CTRL – ALT – DEL followed b ESC
E. CTRL- Shift-6 followed by x

I havent got much technical experience but know general IT terminology as I work for an IT helpdesk and have a IT degree(non technical) and am keen to start studying towards CCNA.
I have spent last couple of weekends on the web trying to locate some good sites that really break the technical knowledge down for a beginner and no luck - i was very surprised !
I have joined a few forums so hopefully will get positive responses.
I also know that sharing knowledge is vital - its a good motivator and things can get cleared up quickly.
I have a 5 day(1st - 5th July) tutor led CCNA course next week.
I want to aim for passing the exam by the end of July.

Please send me as much info as you can regarding .
I would like to know how you think i should proceed from here?
I think I need to get a router sim - any ideas?
What exam prep are you using - questions paper?
How are you planning your own study?
Any one got a CCNA memory sheet?
Ant good study guides on net?
How do you study daily?

Regards

Sunny

PS Tara thankyou for username /passord

Question:-- You are the network administrator of the Ronaldo & Rivaldo's Football Company. You receive a call from a user who is unable to reach a server at a remote site. After further review, you discover the following information:

Local PC – 10.0.3.35/24
Default gateway – 10.0.3.1
Remote server – 10.0.5.250/240
You then conduct the following tests from the offending local PC:
Ping 127.0.0.1 – successful
Ping 10.0.3.35 – successful
Ping 10.0.3.1 – successful
Ping 10.0.5.250 – unsuccessful
Which of the following problems would create the test results listed above?
A. TCP/IP not correctly installed
B. Local physical layer problem
C. Local NIC not functioning
D. Remote physical layer problem

question:-- Which ex command displays system configuration information, software version and the names and sources of configuration files and boot images on a router?
A. show boot
B. show flash
C. show Config
D. show version

Edited by - on Jun 30 2002 12:27:17 AM

Question:-- Which command will provide you with information regarding the Layer 3 configuration of directly connected router interfaces?

A. show ip interface
B. show cdb neighbors
C. show cdp neighbors detail
D. show ip route
E. show ip link status
F. telnet

question:-- Which statement about Ethernet switches is true?

A. Symmetric switching allows connection between ports of unlike bandwidth and does not require memory buffering.
B. Memory buffering is used to prevent a bottleneck when ports of different bandwidth are connected on a symmetric switch.
C. The latency can be reduced if the switch utilizes the store and forward method of switching. Store and forward is better for error detection.
D. The cut-trough method of switching is faster because the switch forwards the packet to the destination as soon as it reads the destination address.