Posted - Mar 09 2001 : 05:06:32 AM
Hi there, in desperate trouble - I accidentally erased the flash memory and the nvram and well, pretty much everything off a 2600 that has a bri, a fastethernet rj45, and a fE 100 Base FX installed. I downloaded one instance of 12.0 which is the correct number, but I think the version I chose (enterprise), was wrong. I think it's wrong because when I loaded it into flash it is only aware of the fastethernet rj45 and neither of the other ports. Do I have to download a different version OR is there something I have to enable or install for it to recognise the ports???
If you can answer this, I'll give you a lollipop . . .
Posted - Mar 09 2001 : 08:16:59 AM
how much ram is on the router and what are you using it for?? Try to download IOS 12.0(7)T. I have found that to be the most stable IOS so far
Posted - May 01 2001 : 2:40:00 PM
Or go to Cisco's Hardware compatability matrix at http://www.cisco.com/cgi-bin/front.x/Support/HWSWmatrix/hwswmatrix.cgi
I had a similar instance with new VWICS and not enough memory. It was in Frankfurt, but one good learning experience.
The material on this web site is not sponsored by, endorsed by or affiliated with Cisco Systems, Inc. CISCO® is a registered trademark of Cisco Systems, Inc.; CCNA™, CCDA™, CCNP™, CCDP™, CCIE™, CISCO CERTIFIED NETWORK ASSOCIATE™, CISCO CERTIFIED DESIGN ASSOCIATE™, CISCO CERTIFIED NETWORK PROFESSIONAL™, CISCO CERTIFIED DESIGN PROFESSIONAL™, CISCO CERTIFIED INTERNETWORK EXPERT™ are distinctive trademarks used by Cisco to describe its certifications and examinations in the United States and certain other countries. All other trademarks are trademarks of their respective owners.
.gif)
Posted - Mar 09 2001 : 05:06:32 AM 
