Practice Tests
|
These tests belong to Networkdesigner.net and not sponsored by, endorsed by or affiliated with Cisco® Systems, Inc.
|
Exam Info
|
This exam info was writen by Networkdesigner.net and not sponsored by, endorsed by or affiliated with Cisco® Systems, Inc.
|
Forums
|
These Forums belong to Networkdesigner.net and not sponsored by, endorsed by or affiliated with Cisco® Systems, Inc.
|
Our Recomended Books
|
These Books are recomended by Networkdesigner.net and not recomended by, sponsored by, endorsed by or affiliated with Cisco® Systems, Inc.
|
|
|
|
Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!
T O P I C R E V I E W |
mccreaj |
Hi there, in desperate trouble - I accidentally erased the flash memory and the nvram and well, pretty much everything off a 2600 that has a bri, a fastethernet rj45, and a fE 100 Base FX installed. I downloaded one instance of 12.0 which is the correct number, but I think the version I chose (enterprise), was wrong. I think it's wrong because when I loaded it into flash it is only aware of the fastethernet rj45 and neither of the other ports. Do I have to download a different version OR is there something I have to enable or install for it to recognise the ports???
If you can answer this, I'll give you a lollipop . . .
|
rasimon1 |
how much ram is on the router and what are you using it for?? Try to download IOS 12.0(7)T. I have found that to be the most stable IOS so far
|
scuda20 |
Or go to Cisco's Hardware compatability matrix at http://www.cisco.com/cgi-bin/front.x/Support/HWSWmatrix/hwswmatrix.cgi
I had a similar instance with new VWICS and not enough memory. It was in Frankfurt, but one good learning experience.
|
vhp43 |
scuda20 was right, the matrix on cisco's website will help you - I ran into the same problem, and once I found the correct version of IOS for my 2600 I was cool.
quote:
Hi there, in desperate trouble - I accidentally erased the flash memory and the nvram and well, pretty much everything off a 2600 that has a bri, a fastethernet rj45, and a fE 100 Base FX installed. I downloaded one instance of 12.0 which is the correct number, but I think the version I chose (enterprise), was wrong. I think it's wrong because when I loaded it into flash it is only aware of the fastethernet rj45 and neither of the other ports. Do I have to download a different version OR is there something I have to enable or install for it to recognise the ports???
If you can answer this, I'll give you a lollipop . . .
|
|
|
|